Masport Colorado Operations Instructions

Browse online or download Operations Instructions for Fireplaces Masport Colorado. Masport Colorado Operating instructions User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 2 - (Some freestanding models)

TESTED NEW ZEALAND FLUES:- In New Zealand we recommend the use of genuineMasport flue kits or kits approved by Masport. The flue MUST be installed in

Page 3 - CONTENTS

INSTALLING A WATER HEATING BOOSTERWater heating booster tubes can be fitted to Masport woodfires but the local emission regulations insome areas may p

Page 4 - INTRODUCTION

FIREPLACE INSERT MODELS (See page 3 for free-standing models)NOTE. The following instructions cover the installation of any Provincial heat

Page 5 - UNPACKING

FLOOR PROTECTOR AND MANTEL-SHELF REQUIREMENTS « N

Page 6 - AUSTRALIA

MANTEL-SHELF SHIELDINGMantel-shelves wider or lower than those shown can be used provided that they have heat shieldsbelow them. We recommend a sheet

Page 7 - Protector Dimensions

OPERATING INSTRUCTIONS — ALL MODELSBASIC INFORMATIONDOOR HANDLEFront mounted handles. Swing the door open and shut with the handle in the 1 o’clock po

Page 8

When the kindling is well alight, open the door slowly and add some larger pieces of wood. Do notthrow fuel pieces into the firebox as this may damage

Page 9 - INSTALLING THE FLUE

SAFETY• Always keep children well away from the woodfire when it is alight.• The appliance is not intended for use by young children or in

Page 10

SECONDARY AIR TUBE REMOVALThe tube will have either one or two removable angle pins to prevent it from moving endways andfalling out. If there is one

Page 11

Fans on in-built fires can be accessed by lifting off the ash shelf. Fans on free-standing fires arereached by removing the rear of the pedestal

Page 12 - FIREPLACE INSERT MODELS

THE INSTALLATION AND OPERATING INSTRUCTIONS IN THIS MANUAL APPLYTO THE FOLLOWING WOODFIRES:-(Softwood and Hardwood refer to the fuel used for emission

Page 13

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid electr

Page 14 - only the manufacturer, the

CONTENTSINTRODUCTION...2FREE-STANDING MODELS — INSTALLATIONUNPACKING...

Page 15 - LIGHTING UP

INTRODUCTIONIn the interests of your safety, most building regulatory Authorities in Australia and NewZealand require any woodfire instal

Page 16

FREE-STANDING MODELS (See page 11 for in-built models)UNPACKINGAfter removal of the shipping carton, open the door and lift it from its hinges. Do not

Page 17 - MAINTENANCE

POSITIONING YOUR FREE-STANDING WOODFIREFree-standing woodfires must not be installed in a fireplace or alcove, or under a ceiling of less than2.3m hei

Page 18

§ Valid only when the room walls are at 90° to each other.‡ Note: Clearances are for fire hazard only. For durability of finishes or surfaces you shou

Page 19 - FAN WIRING DIAGRAMS

AUSTRALIAALL WITH FLUE HEAT SHIELDA # C# G H J K L W S #LE 2000 - hardwood 125 295 170 435 555 160 300 875 860LE 3000 – Series 2 - hardwood 150* 375*

Page 20 - DIMENSIONS

FLOOR PROTECTOR (Hearth) CONSTRUCTIONIn Australia the minimum floor protection requirement is a sheet of 6mm fibre cement board. It isusually fastene

Comments to this Manuals

No comments